English 4 Dansk 15 DEutsch 25 37 suomi 49 norsk 59 svEnska 70 89 100 hQ7130,hQ7120 4 English important Read this user manual carefully before you use the appliance and save it for future reference. - This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. - Children should be supervised to ensure that they do not play with the appliance. - Only use the powerplug supplied. - The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. - The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this causes a hazardous situation. - Do not use a damaged powerplug. - If the powerplug is damaged, always have it replaced with one of the original type in order to avoid a hazard. - Make sure the powerplug does not get wet. - Charge and store the shaver at a temperature between 5°C and 35°C. - Always unplug the shaver before cleaning it under the tap. - The appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. - This washable shaver is not suitable for shaving in the shower. English - Do not immerse the shaver in water. 5 - Water may leak from the socket at the bottom of the appliance when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. To extend the lifetime of the battery: - do not charge the shaver for more than 12 hours. - only charge the shaver when the battery-low light goes on. Electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. charging Make sure the appliance is switched off before you start to charge it. Charging takes approx. 8 hours. To extend the lifetime of the battery, do not charge the shaver for more than 12 hours. English Charge indications charging , When you start charging the empty shaver, the charging light goes on. Batteryrunninglow , When the battery is running low, the battery-low light goes on. When you switch off the shaver, this light flashes a few times. Cordless shaving time After charging, the shaver has a cordless shaving time of up to 30 minutes. chargingtheappliance Only charge the shaver when the battery-low light goes on. 1 Put the appliance plug in the shaver. 2 Put the powerplug in the wall socket. 3 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the battery has been fully charged (after approx. 8 hours). Using the appliance The shaver cannot be used directly from the mains. English Shaving 1 Press the on/off button once to switch on the shaver. The power-on lights go on to indicate that the motor is running. 7 2 Move the shaving heads quickly over your skin, making both straight and circular movements. - Shaving on a dry face gives the best results. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 3 Press the on/off button once to switch off the shaver. The power-on lights go out. 4 Clean the shaver (see chapter `Cleaning and maintenance'). 5 Put the protection cap on the shaver every time you have used it, to prevent damage to the shaving heads. trimming For grooming sideburns and moustache. 1 Open the trimmer by pushing the slide downwards. The trimmer can be activated while the motor is running. 2 Close the trimmer (`click'). 8 English Cleaning and maintenance Regular cleaning guarantees better shaving performance. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. Note:Water may leak from the socket at the bottom of the appliance when you rinse it.This is normal and not dangerous. Every day: shaving unit and hair chamber 1 Switch off the shaver. 2 Press the release button to open the shaving unit. 3 Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. , Make sure you clean the inside as well as the outside of the shaving unit. 4 Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. English 5 Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied. 9 Every six months: shaving heads 1 Open the shaving unit, turn the lock anticlockwise (1) and remove the retaining frame (2). 2 Clean the cutters and guards with the brush supplied. Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. 3 Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit and turn the lock clockwise. 4 Close the shaving unit. trimmer Clean the trimmer every time you have used it. 1 Switch off the shaver. 10 English 2 Clean the trimmer with the brush supplied. 3 Lubricate the trimmer teeth with a drop of sewing machine oil every six months. storage , Put the protection cap on the shaver to prevent damage to the shaving heads. replacement , Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ8 Philips shaving heads only. Note: Do not mix up the cutters and the guards to guarantee optimal shaving performance. 1 Switch off the shaver. 2 Press the release button to open the shaving unit. English 11 3 Turn the lock anticlockwise (1) and remove the retaining frame (2). 4 Remove the shaving heads and place new ones in the shaving unit. Put the retaining frame back into the shaving unit and turn the lock clockwise. Make sure that the projections of the shaving heads fit exactly into the recesses. 5 Close the shaving unit. Accessories The following accessories are available: - HQ8500/HQ8000 powerplug. - HQ8 Philips Shaving Heads. - HQ110 Philips Shaving Head Cleaning Spray. - HQ8010 car cord. Environment - Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment. Disposal of the battery The built-in rechargeable NiMH battery contains substances that may pollute the environment. 12 English Always remove the battery before you discard and hand in the appliance at an official collection point. Dispose of the battery at an official collection point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre. The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way. Only remove the battery if it is completely empty. 1 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 2 Let the shaver run until it stops, undo the two screws in the hair chamber and remove it. 3 Undo the two screws at the back of the shaver and remove the back panel of the housing. 4 Remove the side panels by pulling them off the sealed power unit. 5 Undo the three screws in the sealed power unit. English 13 Remove the back panel of the sealed power unit by means of a screwdriver. 7 Remove the battery. Be careful, the battery strips are very sharp. Do not connect the shaver to the mains again after the battery has been removed. Guarantee & service If you need information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. Guarantee restrictions The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear. Troubleshooting 1 Reduced shaving performance. Cause 1: the shaving heads are dirty.The shaver has not been rinsed long enough or the water used was not hot enough. , Clean the shaver thoroughly before you continue shaving. See chapter `Cleaning and maintenance'. Cause 2: long hairs are obstructing the shaving heads. 14 English , Clean the cutters and guards with the brush supplied. See chapter `Cleaning and maintenance', section `Every six months: shaving heads'. Cause 3: the shaving heads are damaged or worn. , Replace the shaving heads. See chapter `Replacement'. 2 The shaver does not work when the on/off button is pressed. The battery is empty. , Recharge the battery. See chapter `Charging'. 3 The shaving unit has come off the shaver. The shaving unit has not been placed correctly. , If the shaving unit becomes detached from the shaver, you can easily put it back by inserting the hinge into the slot in the rim of the hair chamber and pushing it home until it locks into place (`click'). Dansk 15 vigtigt Læs denne brugsvejledning omhyggeligt igennem, inden apparatet tages i brug, og gem den til eventuelt senere brug. - Dette apparat er ikke beregnet til at blive brugt af personer (herunder børn) med nedsatte fysiske og mentale evner, nedsat følesans eller manglende erfaring og viden, medmindre de er blevet vejledt eller instrueret i apparatets anvendelse af en person, der er ansvarlig for deres sikkerhed. - Apparatet bør holdes uden for børns rækkevidde for at sikre, at de ikke kan komme til at lege med det. - Brug kun det medfølgende netstik. - Net/transformerstikket omformer 100-240 Volt til en lav sikkerhedsspænding under 24 Volt. - Netstikket indeholder en transformer. Derfor må det aldrig klippes af og udskiftes med et andet stik, da det vil resultere i en farlig situation. - Brug aldrig et beskadiget netstik. - Hvis netstikket beskadiges, må det kun udskiftes med et originalt netstik af samme type for at undgå enhver risiko ved efterfølgende brug. - Sørg for, at netstikket ikke bliver vådt. - Shaveren skal oplades og opbevares ved en temperatur mellem 5° C og 35° C. - Tag altid stikket ud af shaveren, inden den skylles under vandhanen. - Produktet opfylder de internationalt godkendte IEC-sikkerhedsregler og kan skylles under rindende vand uden risiko. Vær forsigtig med varmt vand. Kontrollér altid, at vandet ikke er for varmt, så du ikke skolder dine hænder. - Denne vaskbare shaver er ikke beregnet til brug i brusebadet. 1 Dansk - Kom aldrig shaveren ned i vand. - Når shaveren rengøres, kan der dryppe lidt vand ud af stikket i bunden. Dette er helt normalt og ganske ufarligt, da al elektronikken er indkapslet i en forseglet motorenhed inde i shaveren. Sådan forlænges batteriets levetid: - oplad aldrig shaveren i mere end 12 timer i træk. - genoplad kun shaveren, når indikatoren for lav batterikapacitet lyser. Elektromagnetiske felter (EMF) Dette Philips-apparat overholder alle standarder for elektromagnetiske felter (EMF). Ved korrekt anvendelse i overensstemmelse med instruktionerne i denne brugsvejleding, er apparatet sikkert at anvende, ifølge den videnskabelige viden, der er tilgængelig i dag. Opladning Kontrollér, at apparatet er slukket, før opladningen påbegyndes. En fuld opladning tager ca. 8 timer. For at forlænge batteriets levetid, skal du undlade at oplade shaveren i mere end 12 timer i træk. Dansk 17 Opladningsindikatorer Opladning , Når opladning af shaveren påbegyndes, lyser opladeindikatoren. Lav batterikapacitet , Når batteriet er ved at løbe tør for strøm, tænder indikatoren for lav batterikapacitet. Når du slukker for shaveren, blinker den et par gange. Ledningsfri brugstid En fuld opladning giver op til 30 minutters ledningsfri brugstid. Opladning Genoplad kun shaveren, når indikatoren for lav batterikapacitet lyser. 1 Sæt apparatstikket ind i shaveren. 2 Sæt netstikket i stikkontakten. 3 Så snart shaveren er ladet helt op, tages stikket ud af stikkontakten og apparatstikket ud af shaveren (efter ca 8 timer). Sådan bruges apparatet Shaveren kan ikke køre direkte fra stikkontakten. 18 Dansk Barbering 1 Tryk en gang på on/off-knappen for at tænde for shaveren. Kontrollampen tænder for at vise, at motoren kører. 2 Bevæg skærene hurtigt hen over huden både i lige strøg og i cirkelbevægelser. - Resultatet bliver bedst, hvis huden er tør. - Vær opmærksom på, at der kan gå 2-3 uger, før din hud helt har vænnet si ...