CD RDS RECEIVER REPRODUCTOR DE CD CON RECEPTOR RDS CD PLAYER COM RDS English Español Português (B) DEH-6350SD Owner's Manual Manual de instrucciones Manual do proprietário Section 01 Contents Before You Start Before You Start About this unit 2 Demo mode 2 In case of trouble 2 About this manual 3 Operating this unit Head unit 3 Remote control 3 Display indication 4 Basic Operations 4 Use and care of the remote control 4 Menu operations identical for function settings/audio adjustments/initial settings/lists 5 Tuner 5 CD/CD-R/CD-RW and external storage devices (USB, SD) 6 iPod 6 Audio Adjustments 8 Initial Settings 9 Other Functions 10 Installation Connections Installation Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. About this unit CAUTION ! Do not allow this unit to come into contact with liquids. Electrical shock could result. Also, damage to this unit, smoke, and overheating could result from contact with liquids. ! Always keep the volume low enough to hear outside sounds. ! Avoid exposure to moisture. ! If the battery is disconnected or discharged, any preset memory will be erased. CAUTION: USE OF CONTROL OR ADJUSTMENT OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. CAUTION: THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARD. Note Function setting operations are completed even if the menu is cancelled before the operations are confirmed. Demo mode Important Failure to connect the red lead (ACC) of this unit to a terminal coupled with ignition switch on/off operations may lead to battery drain. 10 11 Additional Information Troubleshooting 13 Error messages 13 Handling guidelines 14 Compressed audio compatibility (disc, USB, SD) 15 iPod compatibility 16 Sequence of audio files 16 Copyright and trademark 16 Specifications 17 CAUTION This product is a class 1 laser product classified under the Safety of laser products, IEC 60825-1:2007, and contains a class 1M laser module. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. Refer all servicing to qualified personnel. Demo mode The demo automatically starts when the ignition switch is set to ACC or ON while the unit is turned off. Turning off the unit does not cancel demo mode. To cancel the demo mode, press /DISP/SCRL. Press /DISP/SCRL again to start. Operating the demo while the ignition switch is set to ACC may drain battery power. In case of trouble CAUTION--CLASS 1M INVISIBLE LASER RADIATION WHEN OPEN, DO NOT VIEW DIRECTLY WITH OPTICAL INSTRUMENTS. Should this unit fail to operate properly, please contact your dealer or nearest authorized PIONEER Service Station. 2 En Section Before You Start Operating this unit 02 English About this manual ! In the following instructions, USB memories, USB portable audio players, and SD memory cards are collectively referred to as "external storage devices (USB, SD)." If only USB memories and USB portable audio players are indicated, they are collectively referred to as "USB storage devices." ! In this manual, iPod and iPhone will be referred to as "iPod". Head unit 12 3 4 56 Remote control e a l c b a9 87 k b j f g h i d Part Part 1 8 Part AUX input jack (3.5 mm stereo jack) /DISP OFF BAND/ESC SRC/OFF /DISP/SCRL Removing the front panel, you can see the SD memory card slot. h AUDIO g a/b/c/d e f VOLUME MUTE Press to increase or decrease volume. Press to mute. Press again to unmute. Press to perform manual seek tuning, fast forward, reverse and track search controls. Also used for controlling functions. Press to select an audio function. Press to select different displays. Press and hold to scroll through the text information. Press to pause or resume playback. Press to select functions. Press and hold to recall the initial setting menu when the sources are off. Press to display the list depending on the source. While in the operating menu, press to control functions. En Operation (list) MULTI-CONTROL (M.C.) 1 to 6 Disc loading slot h (eject) 2 3 4 5 9 a b c 6 USB port d i DISP/SCRL 7 Detach button j e CAUTION Use an optional Pioneer USB cable (CD-U50E) to connect the USB audio player/USB memory as any device connected directly to the unit will protrude out from the unit and may be dangerous. Do not use unauthorized products. k FUNCTION l LIST/ ENTER 3 Section 02 Operating this unit Operating this unit Display indication 1 2 3 Basic Operations ! ! Important Handle gently when removing or attaching the front panel. Avoid subjecting the front panel to excessive shock. Keep the front panel out of direct sunlight and high temperatures. To avoid damaging the device or vehicle interior, remove any cables and devices attached to the front panel before detaching it. Removing the front panel to protect your unit from theft 1 Press the detach button to release the front panel. 2 Push the front panel upward and pull it toward you. Selecting a source 1 Press SRC/OFF to cycle between: TUNER (tuner)--CD (built-in CD player)--USB (USB)/USB-iPod (iPod)--SD (SD memory card)--AUX (AUX) Adjusting the volume 1 Turn M.C. to adjust the volume. 4 Indicator Information display section LOC (random) (shuffle) 2 (repeat) (SD memory card) (sound retriever) Level meter display section Main display section State ! ! CAUTION 3 Always keep the detached front panel in a protection device such as a protection case. Re-attaching the front panel 1 Slide the front panel to the left. Make sure to insert the tabs on the left side of the head unit into the slots on the front panel. 1 Source, band, and menu operation guides are displayed. Local seek tuning is on. The random function is on. The iPod source is selected and the shuffle or shuffle all function is on. The repeat function is on. SD/SDHC memory card is inserted. The sound retriever function is on. For safety reasons, park your vehicle when removing the front panel. Note When this unit's blue/white lead is connected to the vehicle's auto-antenna relay control terminal, the vehicle's antenna extends when this unit's source is turned on. To retract the antenna, turn the source off. Use and care of the remote control 2 Press the right side of the front panel until it is firmly seated. If you cannot attach the front panel to the head unit successfully, make sure that you are placing the front panel onto the head unit correctly. Forcing the front panel into place may result in damage to the front panel or head unit. Turning the unit on 1 Press SRC/OFF to turn the unit on. Turning the unit off 1 Press and hold SRC/OFF until the unit turns off. Using the remote control 1 Point the remote control in the direction of the front panel to operate. When using for the first time, pull out the film protruding from the tray. Replacing the battery 1 Slide the tray out on the back of the remote control. 2 Insert the battery with the plus (+) and minus (­) poles aligned properly. 3 The levels of the audio outputs are displayed. Tuner: frequency Built-in CD, external storage device (USB, SD) and iPod: elapsed playback time and text information 4 4 En Section Operating this unit Operating this unit 02 English WARNING ! Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor immediately. ! Batteries (battery pack or batteries installed) must not be exposed to excessive heat such as sunshine, fire or the like. Menu operations identical for function settings/audio adjustments/initial settings/ lists Returning to the previous display Returning to the previous list/category (the folder/ category one level higher) 1 Press /DISP/SCRL. Returning to the main menu Returning to the top tier of the list/category. 1 Press and hold /DISP/SCRL. Returning to the ordinary display Canceling the initial setting menu Returning to the ordinary display from the list/category 1 Press BAND/ESC. Basic Operations Selecting a band 1 Press BAND/ESC until the desired band (FM1, FM2, FM3 for FM or AM) is displayed. Manual tuning (step by step) 1 Push M.C. left or right. Seeking 1 Push and hold M.C. left or right, and then release. You can cancel seek tuning by pushing M.C. left or right. While pushing and holding M.C. left or right, you can skip stations. Seek tuning starts as soon as you release M.C. Switching the display Selecting the desired text information % Press /DISP/SCRL. Program service name--Frequency # The frequency appear on the display for eight seconds. CAUTION ! Use one CR2025 (3 V) lithium battery. ! Remove the battery if the remote control is not used for a month or longer. ! There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type. ! Do not handle the battery with metallic tools. ! Do not store the battery with metallic objects. ! If the battery leaks, wipe the remote control completely clean and install a new battery. ! When disposing of used batteries, comply with governmental regulations or environmental public institutions' rules that apply in your country/area. Important ! Do not store the remote control in high temperatures or direct sunlight. ! The remote control may not function properly in direct sunlight. ! Do not let the remote control fall onto the floor, where it may become jammed under the brake or accelerator pedal. Note Depending on the area, you cannot switch the display. Function settings 1 Press M.C. to display the main menu. 2 Turn M.C. to change the menu option and press to select FUNCTION. 3 Turn M.C. to select the function. After selecting, perform the following procedures to set the function. BSM (best stations memory) BSM (best stations memory) automatically stores the six strongest stations in the order of their signal strength. 1 Press M.C. to turn BSM on. To cancel, press M.C. again. LOCAL (local seek tuning) Local seek tuning lets you tune in to only those radio stations with sufficiently strong signals for good reception. 1 Press M.C. to display the setting mode. 2 Turn M.C. to select the desired setting. FM: OFF--LEVEL1--LEVEL2--LEVEL3-- LEVEL4 AM: OFF--LEVEL1--LEVEL2 The highest level setting allows reception of only the strongest stations, while lower levels allow the reception of weaker stations. 3 Press M.C. to confirm the selection. En Storing and recalling stations for each band Using preset tuning buttons 1 When you find a station that you want to store in memory, press one of the preset tuning buttons (1 to 6) and hold until the preset number stops flashing. 2 Press one of the preset tuning buttons (1 to 6) to select the desired station. # You can also recall stored radio stations by pushing M.C. up or down during the frequency display. Tuner Important If you are using this unit in North, Central or South America, reset the AM tuning step (refer to AM STEP (AM tuning step) on page 9). Using the preset screen 1 Press to switch to the preset screen. 2 Use M.C. to store the selected frequency in the memory. Turn to change the preset number. Press and hold to store. 3 Use M.C. to select the desired station. Turn to change the station. Press to select. 5 Section 02 Operating this unit Operating this unit CD/CD-R/CD-RW and external storage devices (USB, SD) Basic Operations Playing a CD/CD-R/CD-RW 1 Insert the disc into the disc loading slot with the label side up. Ejecting a CD/CD-R/CD-RW 1 Press h (eject). Playing songs on a USB storage device 1 Open the USB connector cover and plug in the USB storage device using a USB cable. Stopping playback of files on a USB storage device 1 You may disconnect the USB storage device at any time. Playing songs on an SD memory card 1 Remove the front panel. 2 Insert an SD memory card into the SD card slot. Insert it with the contact surface facing down, and press on the card until it clicks and completely locks into place. 3 Re-attach the front panel. 4 Press SRC/OFF to select SD as the source. Playback will start. Stopping playback of files on an SD memory card 1 Remove the front panel. 2 Press on the SD memory card until it clicks. The SD memory card is ejected. 3 Pull out the SD memory card. 4 Re-attach the front panel. Selecting a folder 1 Push M.C. up or down. Selecting a track 1 Push M.C. left or right. Fast forwarding or reversing 1 Push and hold M.C. left or right. Returning to root folder 1 Press and hold BAND/ESC. Switching between compressed audio and CD-DA 1 Press BAND/ESC. Viewing a list of the files (or folders) in the selected folder 1 When a folder is selected, press M.C. Playing a song in the selected folder 1 When a folder is selected, press and hold M.C. 3 Turn M.C. to select the function. After selecting, ...